Location Of Your Washer; Rough-In Dimensions - GE WSSH300 Manual Del Propietario E Instrucciones De Instalación

LOCATION OF YOUR WASHER

Do Not Install the Washer:
1. In an area exposed to dripping water or outside
weather conditions. The ambient temperature
should never be below 60°F (15.6°C) for proper
washer operation.
2. In an area where it will come in contact with curtains
or drapes.
3. On carpet. The floor MUST be a hard surface with
a maximum slope of 1/2" per foot (1.27 cm per
30 cm). To make sure the washer does not vibrate
or move, you may have to reinforce the floor.
IMPORTANT:
Minimum Installation Clearances
• When installed in alcove: Sides, Rear,
Top = 0" (0 cm)
• When installed in closet: Sides, Rear,
Top = 0" (0 cm), Front = 1" (2.54 cm)
• Closet door ventilation openings required:
2 louvers each 60 square in. (387 cm
(7.6 cm) from top and bottom of door
Undercounter Installation
If an undercounter* installation is desired, you MUST
install a top sheet kit, 14-A037. This kit is available through
your GE retailer.
*Custom-sized countertop is required.
Mobile Home Installation
Installation must conform to Standard for Mobile Homes,
ANSI A119.1 and National Mobile Home Construction
and Safety Standards Act of 1974 (PL93-383).
Stacked Installation
If a stacked washer/dryer installation is desired,
you MUST use Stacking Kit WE25X10020 or 14-A026.
This kit is available through your GE retailer.
Installation Instructions
), located 3"
2
12

ROUGH-IN DIMENSIONS

27
(70.5 cm)
"
3 3 ⁄
4
(9.5 cm)
"
8 1 ⁄
2
(21.6 cm)
36"
"
2 3 ⁄
(91.3 cm)
4
(7 cm)
Drain
"
32 1 ⁄
4
(81.9 cm)
"
3 ⁄
4
24"
60"
(61 cm)
(152.4 cm)
Power Cord
(84.8 cm)
SIDE
27"
(68.6 cm)
6 3
(17.1 cm)
Water Inlets
33
(85.1 cm)
REAR
"
33 ⁄
3
8
"
⁄
4
"
1 ⁄
2