Other Functions; Storage And Cleaning - SOLAC PV1810 Instrucciones De Uso

OTHER FUNCTIONS

ANTI-LIMESCALE SYSTEM (
This iron has an innovative built-in anti-limescale system, consisting of a resin filter that
retains the limescale substances from the water, so these cannot reach the steam chamber
of the soleplate, thus extending the life of the iron.
The existence of this anti-limescale system does not mean that the recommendations about
water hardness mentioned in the "BEFORE STARTING TO IRON" section can be ignored.
ANTI-DRIP SYSTEM (
The iron incorporates an anti-drip system that prevents the iron from dripping, even when it
is switched off.

STORAGE AND CLEANING

)
Clean the appliance after using it for the first time, immediately after each use and after
a long time without use.
SOLEPLATE
1 Disconnect the iron and allow the soleplate to cool down.
,
Use clay-based, environmentally friendly products to clean the soleplate.
EXTERNAL PART
1 To clean the external part of your iron, use a cloth dampened with soapy water.
,
Do not use solvents or abrasive products to clean your iron, as these could damage
some of the plastic parts and/or remove some of the marks
2 Store your iron in a vertical position, coiling the cord around the base and pressing the
cable into the fixing clip.
)
Although the power cord is fitted with a 360º swivel piece, NEVER FORCE this
cord when coiling it around the appliance on the first turn.
SELF-CLEANING
)
It is advisable to carry out the self-cleaning operation about once a month, depending
on the frequency of use and the hardness of the water used.
1 Ensure that the tank is half filled with water.
2 Place the iron in the vertical position.
3 Plug in the iron and turn the temperature selector (9) to the Max position.
4 Wait for the pilot light to go off (11) indicating that the desired temperature has been reached.
5 Turn the temperature selector (9) to the 0 position and unplug the iron from the mains.
6 Place the iron in the horizontal position over the sink or a suitable receptacle.
7 Set the steam selector (10) to the self-cleaning position
To do so, press the steam selector down and turn (fig. 6).
8 Swing the iron gently from side to side. Steam and water will come out of the holes in
the iron, flushing out dirt and impurities (fig. 7).
n
Be careful when performing this operation, as the water and steam are very hot and
can cause burns.
9 Place the iron in the vertical position and wait for it to cool completely.
10 Wipe the soleplate with a damp cloth.
)
Remember that damage caused by the effects of limescale is not covered in the
warranty.
OTHER FUNCTIONS
only Mod. PV 2010 and PV2210)
only Mod. PV2210)
to open the water circuit.
en
15