Bosch 1772-6 Instrucciones De Funcionamiento Y Seguridad página 10

BM 2610009659 03-10 :BM 2610009659 03-10 3/9/10 7:24 AM Page 10
Functional Description and Specifications (Continued)
NOTE: For tool specifications refer to the nameplate on your tool.
NOTE: Not recommended for use with type 11 cup wheels.
WHEEL GUARD INSTALLATION
Use wheel guard with disc
W RNING
grinding wheels. Always
close the latch to secure the guard. Keep the
guard between you and the wheel. Do not
direct guard opening toward your body.
The position of the guard can be adjusted to
accommodate the operation being performed.
To attach wheel guard DISCONNECT tool
from power source.
Open guard release/lock latch and position
guard on spindle neck so that the notched on
guard, line up with the keys on the spindle
neck (Fig. 2).
The tightening tension of the clamp from the
protection guard can be changed by loosening
or tightening the adjustment screw. Ensure
that the protection guard is tighly seated and
check regularly.
Rotate guard either direction to desired
position, and close latch to secure guard in
place.
TO REMOVE
release/lock latch, rotate guard until the
LOCK NUT AND BACKING FLANGE
Your tool is equipped with a threaded spindle
for mounting accessories. Always use the
supplied lock nut (and backing flange) that
has same thread size as spindle.
SIDE HANDLE
The side handle is used to control and balance
the tool. The handle must be threaded into the
front housing on either side of the tool,
depending on personal preference and
comfort. Use the side handle for safe control
and ease of operation (Fig. 1).
NOTE: Always use appropriate size wheel guard.
Assembly
GUARD: Open guard
notches on guard line up with the keys on the
spindle neck, and lift guard off the spindle neck
(Fig. 2).
FIG. 2
KEYS
GU RD
RELE SE / LOCK
L TCH
NOTCHES
DJUSTMENT
SCREW
OPTIONAL HAND GUARD
The hand guard is to be used with backing
pads and sanding discs to keep fingers and
hand away from work surface, sharp edges,
burrs and debris. When using the optional
hand guard accessory insert side handle
through hole in guard and then thread into
housing (Fig. 1).
Ensure that hand guard is positioned between
hand and backing pad or sanding disc.
-10-
SPINDLE
TYPE 27
WHEEL
GU RD