Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2610009659 03-10 :BM 2610009659 03-10 3/9/10 7:24 AM Page 11
TYPE 27, 28 & 29 GRINDING
WHEEL ASSEMBLY
Disconnect tool from power source. Be sure
that wheel guard is in place for grinding.
When using mounting wheels, thread
BACKING FLANGE all the way down onto
spindle, then place GRINDING WHEEL on
the spindle. Thread on the lock nut and
tighten nut using a lock nut wrench provided
with flange kit, while holding the spindle lock
in (Fig. 3).
TO REMOVE: Reverse procedure.
When using spin-on grinding wheels, thread
directly onto the spindle.
ABRASIVE TYPE 1A & 27A
WHEEL ASSEMBLY
Using the optional type 1A wheel guard, it is
possible to perform limited cutting on small
stock such as metal tubes, piping or rebar.
Do not attempt to cut large stock or sheets of
metal as this tool is not designed to be a
dedicated cutting tool.
FIG. 3
SPINDLE
TYPE 27
SPIN-ON
GRINDING
WHEEL
W RNING
Disconnect tool from power source. Be sure
that wheel guard is in place for cutting.
When using mounting wheels, thread
BACKING FLANGE all the way down onto
spindle, then place GRINDING WHEEL on
the spindle. Thread on the lock nut and
tighten nut using a lock nut wrench provided
with flange kit, while holding the spindle lock
in (Fig. 4).
TO REMOVE: Reverse procedure.
W RNING
straight/die grinding. This tool is not
designed for use with type 1 abrasive
straight/die grinding wheels.
TYPE 27
WHEEL GU RD
B CKING
FL NGE
TYPE 27
GRINDING
WHEEL
LOCK NUT
TYPE 1
WHEEL
-11-
Always use type 1A protection
guard for cutting.
TYPE 1 ABRASIVE
STRAIGHT GRINDING WHEELS
Do not use type 1 abrasive
wheels
designed
WHEEL GU RD
B CKING
FL NGE
LOCK NUT
for
FIG. 4
SPINDLE
TYPE 1
TYPE 27
WHEEL
Publicidad
