Dexter 20VAG2-125.1 Manual De Instrucciones página 287

2. SAFETY INSTRUCTIONS
loose or cracked wires. If power tool or accessory is dropped,
inspect for damage or install an undamaged accessory. After
inspecting and installing an accessory, position yourself and
bystanders away from the plane of the rotating accessory and
run the power tool at maximum no-load speed for one minute.
Damaged accessories will normally break apart during this test time.
H. Wear personal protective equipment. Depending on
application, use face shield, safety goggles or safety glasses.
As appropriate, wear dust mask, hearing protectors, gloves
and workshop apron capable of stopping small abrasive or
workpiece fragments. The eye protection must be capable of
stopping flying debris generated by various operations. The dust
mask or respirator must be capable of filtrating particles generated by
your operation. Prolonged exposure to high intensity noise may cause
hearing loss.
I. Keep bystanders a safe distance away from work area. Anyone
entering the work area must wear personal protective
equipment. Fragments of workpiece or of a broken accessory may fly
away and cause injury beyond immediate area of operation.
J. Hold the power tool by insulated gripping surfaces only, when
performing an operation where the cutting tool may contact
hidden wiring. Contact with a "live" wire will also make exposed
metal parts of the power tool "live" and could give the operator an
electric shock.
K. Position the cord clear of the spinning accessory. If you lose
control, the cord may be cut or snagged and your hand or arm may be
pulled into the spinning accessory.
L. Never lay the power tool down until the accessory has come to
a complete stop. The spinning accessory may grab the surface and
pull the power tool out of your control.
FR FR
ES ES
PT PT
IT IT
EL EL
PL PL
RU RU
UA KZ
KZ UA
RO RO
BR BR
EN
EN
287