Dexter 20VAG2-125.1 Manual De Instrucciones página 289

2. SAFETY INSTRUCTIONS
kickback or torque reaction during start-up. The operator can
control torque reactions or kickback forces, if proper precautions are
taken.
B. Never place your hand near the rotating accessory. Accessory may
kickback over your hand.
C. Do not position your body in the area where power tool will
move if kickback occurs. Kickback will propel the tool in direction
opposite to the wheel's movement at the point of snagging.
D. Use special care when working corners, sharp edges etc. Avoid
bouncing and snagging the accessory. Corners, sharp edges or
bouncing have a tendency to snag the rotating accessory and cause loss
of control or kickback.
E. Do not attach a saw chain woodcarving blade or toothed saw
blade. Such blades create frequent kickback and loss of control.
Safety Warnings Specific for Grinding and Abrasive Cutting Off
Operations:
A. Use only wheel types that are recommended for your power tool
and the specific guard designed for the selected wheel. Wheels
for which the power tool was not designed cannot be adequately
guarded and are unsafe.
B. The grinding surface of centre depressed wheels must be
mounted below the plane of the guard lip. An improperly
mounted wheel that projects through the plane of the guard lip cannot
be adequately protected.
C. The guard must be securely attached to the power tool and
positioned for maximum safety, so the least amount of wheel
is exposed towards the operator. The guard helps to protect the
operator from broken wheel fragments, accidental contact with wheel
and sparks that could ignite clothing.
D. Wheels must be used only for recommended applications. For
FR FR
ES ES
PT PT
IT IT
EL EL
PL PL
RU RU
UA KZ
KZ UA
RO RO
BR BR
EN
EN
289