TFK twinner lite Instrucciones De Uso página 9

OPERATING AND ASSEMBLY MANUAL
- (Fig.I) In order to be able to use Twinner light, fold the push bar (1)
upwards. The complete pushcar is folded open. Make sure that the
pins are audibly engaged in the lock (2).
- (Fig.II) The seat is mounted to the frame with 4 push buttons (a) on
each side of the frame. Additionally, it is fixed to the foot board with
2 push buttons (b). At first, you must mount the seat at the left side in
direction of driving.
- (Fig.III) Insert the hood into the holders (4) on the outer push bar
and into the holder on the centre push bar. Then it is secured to the
seat and the frame (d) with two push buttons (c). It can be
additionally secured to the centre bar with a belt. If you open the
zipper (5), you can extend the hood further forwards.
- (Fig.IV) For the assembly of the rear wheels, insert the axle (6) in the
frame so that the brake is also located in the holder. Mount the
brake calliper (7) in the M-brake (8). If you want to remove the
wheels, release the brake cable (7) and press the kangaroo button in
the centre of the wheel. Now you can remove the wheels.
- (Fig.V) Insert the front wheel (9) into the provided opening until it
audibly locks into place. At position 1, the front wheel (9) can turn
freely and at position 2, it is jammed. If you press the red button with
the arrow (10), you can remove the wheel downwards. Inside of the
wheel mount there are 2 set screws (11), with which you can adjust
the straight running of the Joggster Twist when necessary.
- (Fig.VI) Both backrests can be continuously adjusted with the belt.
To this end, you must press both plastic parts (13) together and adjust
the seat angle with the belt.
- (Fig.VII) The foot rest can be folded upwards. To this end, it must be
locked in place with the foot board (14).
- (Fig.VIII) Close the belt buckle by audibly engaging both plugs (15)
in the belt buckle (16). If you want to open the harness, simply press
the button in the centre of the buckle (16). The harnesses can be
adjusted to the size of your child using the tensioning system x, y and
z. The harness is located at the 5 points x, y, z.