Skil PWRCORE 12 Manual Del Propietário página 14

NOTICE: Charger may become warm with several continuous charge cycles.This is part of
the normal operation of the charge. Charge in a well ventilated area.
Defective Charger
If the charger self-inspection fails to react when the charger is plugged in, the causes include
no power to the charger, bad contacts, or a defective charger. Check to see if the charger
self-inspection can be activated when the charger is plugged in again or plugged into a
different outlet. If it still fails, have the charger serviced by an Authorized SKIL Service Station.
Defective Battery Pack
If the charger detects a problem, the red Defect Indicator will begin flashing. Remove and
re-insert the battery pack in the charger. If the Defect Indicator flashes a second time, try
charging a different battery pack.
a. If a different battery pack charges normally, have the first defective battery pack serviced by
an Authorized SKIL Service Station.
b. If a different battery pack also indicates "defective," the charger may be defective. Have the
charger serviced by an Authorized SKIL Service Station.
USB Charging Port (Fig . 4)
The charger has a USB port, which can provide
5V 1A output (e.g. mobile phones, E-readers
and any other products of appropriate power
input) when plugged in.
Connect an applicative device with the charger
with a standard USB cable.
Wall-Mount Holes (Fig . 5)
The charger has hanging holes for convenient
storage. Install screws in the wall 2-1/2 inches
(64mm) apart.
Use screws sufficiently strong to hold the
combined weight of the charger and battery
pack.
There is also a slot for conveniently positioning
the cord.
14
Fig. 4
USB charging port
Fig. 5
Hanging
holes
Cord slot