Dishwasher Control Section - Sears Kenmore ULTRA WASH 665.1309 Serie Manual De Uso Y Cuidado

Options
High Temp
Raises main wash temperature to improve cleaning for
loads containing tough, baked-on food.
Sani Rinse
This high temperature option sanitizes your dishes and
glassware in accordance with National Sanitation
Foundation (NSF)/ANSI Standard 184 for Residential
Dishwashers. Certified residential dishwashers are
not intended for licensed food establishments. The
word Sanitized will light at the end of the cycle when
successfully completed. If Sanitization is not achieved
(most often due to cycle interruption) the word Sanitized
will flash.
Heated Dry
Turns the heat element on after the wash portion of the
cycle is over. Use rinse aid with or without the Heated
Dry option for best drying results. Plastic items are less
likely to deform when loaded in the top dish rack.
*The maximum additional water used for any combination of options is 4.8 gal. (18.2 L).
Delay Hours (on some models)
Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak hours
when possible. Delay displays how many hours Before the cycle will begin.
To delay the start
1. Select a wash cycle and options.
Press the DELAY button. Each time you press the DELAY button it will display the next available delay time.
2.
Press START/RESUME to begin the delay countdown.
3.
NOTE: Anytime the door is opened (such as, to add a dish), the START/RESUME button must be pressed again to resume the delay
countdown.
Control Lock Option
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When the Lock indicator is lit, all buttons are
disabled. The dishwasher door can still be opened or closed while the controls are locked.
To turn on the Lock
Press and hold SANI RINSE for 3 seconds. The Lock indicator will light up. If you press any pad while your dishwasher is locked, the
light flashes 3 times.
NOTE: The dishwasher cannot start if the control is locked.
To turn off the Lock
Press and hold SANI RINSE for 3 seconds. The light turns off.
Can be selected
with
SmartWash
Pots & Pans
Normal Wash
SmartWash
Pots & Pans
Normal Wash
Available with
any cycle
except
Quick Rinse

Dishwasher Control Section

What it does
Raises the main
H E
®
wash temperature to
135°F (57°C).
Sani Rinse raises
the main wash
H E
temperature to
®
135°F (57°C)
and the final rinse
temperature to
156°F (69°C).
Turns the heat
element on at the end
of the wash portion
of the cycle.
Added
Added time Water*
to cycle Gallons
(Liters)
0 - 3.9
0:05 to 0:13
(0 - 14.6)
0 - 3.9
0:05 to 1:01
(0 - 14.6)
0:08 to 0:43 0
17