Functional Description - Porter & Cable PCE141 Manual De Instrucciones

fUNcTIoNAl DeScRIPTIoN

figure A
1. Variable speed switch
2. Lock-on button
3. Forward/reverse lever
4. Drilling mode selector
5. Chuck
6. Depth stop rod
7. Side handle
Safety Warnings and Instructions: Drills
WARNING:
1. Hold drill firmly with one hand on the grip and the
other hand on the side handle as shown in figure B.
2. When attaching accessories in the drill chuck,
tighten with all three holes to prevent slippage.
Always expect the stall. Grip the drill firmly with both
hands to control the twisting action and prevent loss of
control which could cause personal injury. If a stall does
occur, release the trigger immediately and determine the
reason for the stall before re-starting.
Assembly
WARNING:
tool is switched off and unplugged.
Attaching the side handle - (figure c)
If your drill is equipped with a side handle, it must be
installed properly to control the drill.
• Turn the grip counterclockwise until you can slide the
side handle (7) onto the front of the tool as shown.
• Rotate the side handle into the desired position.
• Insert the depth stop rod (6) into the mounting hole as shown
in the insert of figure c.
• Set the drilling depth as described under "Setting the
Drilling Depth".
• Tighten the side handle by turning the grip clockwise. Make sure that the side handle is
secure and does not slip.
Inserting a drill bit or other accessory (figure D)
WARNING:
(or any other accessory) by gripping the front part
of the chuck and turning the tool on. Damage to the
chuck and personal injury may occur when changing
accessories.
WARNING:
before starting the tool. A loose bit may eject from tool
causing possible personal injury.
• Open the chuck (5) by turning the collar counterclockwise
To reduce the risk of injury, before assembly, make sure that the
Do not attempt to tighten drill bits
Always ensure the bit is secure
a
5
6
7
B
c
d
5
4
3
1
2
8