Porter & Cable PCE141 Manual De Instrucciones página 6

(when viewed from the chuck end).
• Insert the accessory shaft into the chuck to about 3/4 in. (19 mm) depth, centered in
the jaws.
• Tighten chuck collar by hand by turning the collar clockwise. Place chuck key (8) into
each of the three holes and securely tighten in a clockwise direction.
NoTe: Tighten chuck with all three holes to prevent slippage.
operating Instructions
WARNING:
and follow all safety warnings and instructions prior to using tool.
WARNING:
firmly with both hands to prevent loss of control which could cause personal injury.
WARNING:
gripping the front part of the chuck and turning the tool on. Damage to the chuck
and personal injury may occur when changing accessories.
WARNING:
before making any adjustments or changing accessories.
WARNING:
overload.
Selecting the drilling mode (figure e)
• For drilling in masonry, set the drilling mode selector
(4) to the "hammer symbol" position.
• For drilling in other materials and for fastening, set the
drilling mode selector to the "drill symbol" position.
Selecting the direction of rotation
For drilling and for tightening screws, use forward
(clockwise) rotation. For loosening screws or removing a
jammed drill bit, use reverse (counterclockwise) rotation.
Note: The direction of rotation is also depicted by an arrow
on the forward/reverse lever (3).
Never change the direction of rotation while the motor
is running.
• To select forward rotation, push the forward/reverse
lever to the left (when viewed from the chuck end).
• To select reverse rotation, push the forward/reverse lever to the right (when viewed from
the chuck end).
Setting the drilling depth
• Slacken the side handle (7) by turning the grip counterclockwise.
• Set the depth stop rod (6) to the desired position. The maximum drilling depth is equal
to the distance between the tip of the drill bit and the front end of the depth stop rod.
• Tighten the side handle by turning the grip clockwise. Make sure that the side handle is
secure and does not slip.
Switching on and off
• To switch the tool on, press the variable speed switch (1). The tool speed depends on
how far you press the switch.
• For continuous operation, press the lock-on button (2) and release the variable speed
switch. This option is available only at full speed.
• To switch the tool off, release the variable speed switch. To switch the tool off when in
continuous operation, press the variable speed switch once more and release it.
WARNING:
The drill should only be locked ON when it is held stationary in a drill
press stand or other means; NOT BY HAND! Never unplug the tool with the locking feature
engaged. To do so will cause the tool to start immediately the next time it is plugged in.
Drilling
• Always unplug the drill when attaching or removing accessories. When attaching
accessories in the drill chuck, it is important to securely tighten the chuck using all three
holes to prevent slippage. When using a keyless chuck, hand tighten firmly.
To reduce the risk of serious personal injury, read, understand
It is important to support the work properly and to hold the drill
Do not attempt to tighten drill bits (or any other accessory) by
To reduce the risk of injury, always unplug drill from power supply
To reduce the risk of injury, let the tool work at its own pace. Do not
e
6