dirna Bergstrom bycool green line SLIM FIT IVECO Euro 6 Instrucciones De Montaje página 16

SLIM FIT
EN
Assembly
Recommendations
• Before starting assembly, please read instructions and
follow them during installation process.
• Use the adequate tools for each operation.
Electricity
• Disconnect ignition key.
• Disconnect battery before starting assembly.
• Make sure electric components are securely connected,
checking their correct fitting.
! Warning
If the unit slants during assembly, wait for at least 60
minutes with the unit in horizontal position before starting
it up.
Documentation included
Mounting instructions
Included parts
! Warning
When installing air conditioning equipment on roof, the
upper cabin part must be protected with a cloth or a
protective blanket to avoid possible scratches. When
installing Slim Fit on roof, take into account that, normally,
cabins equipped with a hatch have a strong enough
structure to hold equipment weight. However, if it is not
the case and it is necessary to carry out a cut in the roof
or, although it has a hatch, the material is not resistant
enough (if roof is made of fibre, plastic, etc...), it is the
installer who will have to decide, under his responsibility,
if it is necessary to reinforce the roof to avoid possible
deformations, breaks, water entries, etc., habilitating the
means required to stop it from occurring.
220.AA3.5380
220.RE0.0179
16
Tools
Torx wrenches set
Allen wrenches set
Open-jawed spanner 10, 13, 14
Scissors
Flexo-meter
Symbology
Fragile
Beware of cuts!
Electrical hazard
!
Warnings
!
The installing personnel must have a sufficient
training in vehicles air conditioning.
!
dirna Bergstrom, s.l. shall not be responsible for
breakdowns or damages coming from an inadequate
handling or installation of the equipment or from
modifications and substitutions carried out without
our express and written authorisation.
!
Equipment pre-charged with refrigerating gas.
(Do not handle refrigerating gas circuit).
!
Please see product warranty procedure included in
Troubleshooting.
!
Please see equipment User's Guide for its correct
functioning of the remote control and control panel.
!
Once installation is finished, the following documents
must be handed over to the user: User's Guide,
Warranty and Troubleshooting.
®