Pioneer PDP-S59 Manual De Instrucciones página 5

4. Connect the supplied speaker cables
to the rear of plasma television.
• Connect the cables correctly with respect to the polarity
of the plasma television speaker terminals, that is,
(Gray) to terminals (Red) and
terminals (Black).
Gray
Red
NOTE:
• Press the lever and insert the end of
the cable.
• When you release the lever, it clamps
onto the speaker cable.
Caution
• Be sure to turn the connected devices off and remove
the power cord from the wall outlet beforehand when
changing the connection or installation method.
• If you insert the speaker cable too far so that
the insulation is touching the speaker
terminal, you may not get any sound. Please
insert it with showing the copper wire.
• Check if the end of the speaker cables are
securely connected to the terminals by
slightly tugging on the cable after making
connections. Loose connections may result
in sound dropouts or noise.
• If there is a short in the
exposed lead wire, excessive load may be applied to the
plasma television, resulting in interrupted operation or
malfunction.
cable
cable (Black) to
Black Gray
Black
Red
Speaker terminal
Speaker cable
Speaker terminal
and cables caused by an
5. Connect the other end of the
speaker cables to the speaker.
• Connect the cables correctly with respect to the polarity
of the speaker terminals, that is,
terminals (Red) and cable (Black) to
Black
Black
Speaker terminal
• Incorrect connections of the speaker cable to the right
or left of the plasma television terminals with respect to
the polarity may result in insufficient stereo sound effects,
delivering poor bass sounds or unstable sound image.
• Bundle the cable without pulling.
6. Bundling the cables.
• Bead bands are included with the plasma television.
• Use the bead bands as necessary.
• When tidying up your speaker cables, make sure to
bundle them so that they are not subjected to any
pressure.
Rear of Display
Bead Band
English
cable (Gray) to
terminals (Black).
Red
Gray
Speaker cable
5