Rinsing; Clean Detergent Siphoning Tube; After Each Use; Automatic Cool Down System (Thermal Relief) - Generac Small Pro Power Washer El Manual Del Propietario

2. Prepare detergent solution as required by
job.
3. Insert filter on end of siphoning tube into
detergent solution.
NOTE: Verify siphoning tube and filter remain
fully submerged in detergent while in use.
NOTE: When inserting siphon tube into
detergent solution, route tube to prevent
muffler contact. Contact with muffler while in
use can damage detergent siphoning tube.
4. Start engine.
5. Apply detergent to a dry surface. Start at
lower portion of area to be washed and
work upward
overlapping strokes.
IMPORTANT: Flush the detergent siphoning
system after each use. Contact an authorized
dealer or qualified service center with questions.

Rinsing

WARNING
Risk of Falling. Use of machine creates wet
areas and trip hazards. Be aware of work area
conditions. A fall could result in death
or serious injury.
WARNING
Risk of Falling. Do not use this machine or
any components on elevated surfaces.
Doing so can result in a fall, serious injury,
or death.
1. Remove black detergent nozzle from
lance.
2. Select and install desired high-pressure
nozzle.
3. Point spray gun in safe direction and
squeeze trigger
detergent from system.
4. Keep spray gun a safe distance from area
to be sprayed.
5. Spray gun may kick back when using high
pressure spray. To avoid injury, firmly
grasp spray gun with both hands.
6. Apply a high-pressure spray to a small
area and then inspect surface for damage.
If no damage is found, continue rinsing.
7. Start at top of area to be rinsed, working
down with same overlapping strokes as
used for cleaning.
Clean Detergent Siphoning
Tube
Flush detergent siphoning tube after each use
before stopping the engine.
1. Place detergent siphoning tube/filter in
bucket of clean water.
2. Remove high-pressure nozzle from nozzle
extension.
3. Select and install black detergent nozzle.
4. Flush for 1-2 minutes.
5. Shut engine OFF.
Owner's Manual for Power Washer
using long, even,
(000112)
(000114)
to flush remaining
6. Point spray gun in a safe direction,
squeeze spray gun trigger to release
retained high water pressure. Engage
trigger lock.

After Each Use

DO NOT allow water to remain in unit for long
periods of time. Sediments or minerals can
deposit on pump parts and freeze pump.
Follow these procedures after every use:
1. Shut engine OFF.
2. Turn water supply OFF.
3. Point spray gun in a safe direction, and
squeeze trigger
pressure.
4. Let engine cool.
5. Disconnect hoses from spray gun and
high-pressure outlet on pump. Drain water
from hoses, spray gun, and lance. Use a
rag to wipe off components.
6. Pull recoil handle approximately six times
to remove remaining liquid from pump.
7. Switch fuel valve to OFF.
8. Store unit in a clean, dry area.
NOTE: If storing for more than 30 days, see
Storage.
Automatic Cool Down System
(Thermal Relief)
When power washer runs for 3-5 minutes
without spray gun activation, circulating water
in pump can reach a temperature sufficient to
engage the thermal relief system. The pump is
cooled by discharging water onto ground.
Adjustable Pressure Setting
(if equipped)
The power washer pump is equipped with a
feature that allows you to adjust the pressure
setting. The pump is preset at the factory to
achieve the highest possible pressure. To
decrease the pressure, turn the pressure
control knob counterclockwise to the desired
pressure. Turning the pressure control knob
clockwise until it stops will set the pressure
back to the factory setting.
Operation
to relieve trapped
9