Pressure Washer Rinsing; Automatic Cool Down System - Generac 3500PSI Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Generac Portable Products 3500 PSIPressure Washer
5.
Make sure garden hose is connected to water inlet
Check that high pressure hose is connected to spray
gun and pump and start engine.
6.
Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
7.
Allow detergent to soak in between 3-5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. DO NOT allow detergent
to dry on (prevents streaking).
IMPORTANT:
You must flushthe chemical injection
system after each useby placing the filter into a bucket of
clean water, then run the pressure washer in low pressure
for I-2 minutes.
Pressure
Washer
Rinsing
After you have applied detergent, scour the surface
and rinse it clean as follows:
I.
2.
.
Apply safety latch to spray gun.
Remove black chemical spray tip from nozzle
extension.
Select and install desired high pressure spray tip
following
the instructions "How to Use Spray Tips".
WARNING
Keep spray nozzle between 8 to 24 inchesaway from cleaning
surface.
Operate this unit on a stable surface.
Beextremely careful if you must usethe pressure washer from
a ladder, scaffolding or any other relatively unstable location.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid iniury if gun kicks back.
4.
Increase (decrease) spray pressure by turning pressure
control knob clockwise (counterclockwise) (Figure 7).
Use lower pressure to wash items such as a car or
boat. Use higher pressure to strip paint and degrease
driveways.
5.
Apply a high pressure spray to a small area and check
surface for damage. If no damage is found, assume it is
okay to continue rinsing.
6.
Start at the top of the area to be rinsed, working
down with same overlapping strokes as you used for
cleaning.
Automatic
Cool
Down
System
(Thermal
Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures
above 125°E The system engagesto cool the pump by
discharging the warm water onto the ground.
/
10

Publicidad

Tabla de contenido
loading

Tabla de contenido