Technical Data; Before Starting The Equipment; Operation; Continuous Operation - EINHELL TE-MX 1600-2 CE Manual De Instrucciones

4. Technical data

See warranty card of your country.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Warning!
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect con-
ditions.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Anl_SA_TE_MX_1600_2_CE_SPK8.indb 17 Anl_SA_TE_MX_1600_2_CE_SPK8.indb 17
GB
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
Mixer assembly (Fig. 2-3):
First scew mixer part (6a) together with mixer part
(6b). Screw the mixer (6) into the mixer holder (4)
afterwards. Use the two spanners to do this. Use
one of the spanners (7a) to hold the mixer holder
(4) in place and then use the second spanner (7b)
to tighten up the mixer (6). Proceed in the reverse
sequence to undo the mixer.
is secure (pull the mains plug).

6. Operation

6.1 ON/OFF switch (Fig. 4/Item 1)
First fi t a suitable mixing tool to the equipment
(see 5.)
Connect the mains plug to a suitable socket.
To switch on:
Press the ON/OFF switch (1)

Continuous operation:

Secure the ON/OFF switch (1) with the locking
button (3).
To switch off :
Press the ON/OFF switch (1) briefl y.
- 17 -
23.11.2016 07:41:34 23.11.2016 07:41:34