Camera Check - NAMCO Grand Prix 2 Manual Del Operador

6-2-2-2 (d)
1. Press the Service button to select CAMERA CHECK and press the Test button.
The following screen is displayed.
V POSITION
H POSITION
EXIT
2. Press the Service button to select the required item then press the Test button.
3. Press the Service button to select 'EXIT' then press the Test button to return to
the I/O Test Menu Screen.
•
Standard settings (factory default) are indicated in green, others are in red.
•
An image captured based on the current settings is shown in the centre of the screen.
(a) MIRROR/PHOTO
When the Item button is pressed, the camera takes a picture.
When a picture is taken, the captured still image is shown at the centre of the
screen, and the indication below the image changes to "PHOTO". This will be the
image shown on the race screen during the game.
When the Item button is pressed again, the still image changes to a moving
image. In this mode the indication below the image changes to "MIRROR".
Set the image mode to "MIRROR" when adjusting the image quality or position.
Set the image mode to "PHOTO" when checking the image to be displayed
during the game.
(b) This adjusts the position of the camera image in a vertical direction.
When"V POSITION" is selected, the cursor moves to the "UP" position. To move
the image up, press the Service switch. To move the image down, press the Test
switch to move the cursor to "DOWN", then press the Service switch.
When the Test switch is pressed again, the cursor returns to the "V POSITION"
UP:
DOWN: The numerical value decreases, and the displayed image moves in a
56

Camera Check

I/O TEST
CAMERA CHECK
MIRROR
TAKE A PHOTO AND RELEASE : ITEM BUTTON
UP
LEFT
SELECT WITH SERVICE BUTTON
AND PRESS TEST BUTTON
The numerical value increases, and the displayed image moves in an
upward direction.
downward direction.
DOWN [+000]
RIGHT [+000]
(a)
(b)
(c)