Fitting The Ride Assembly; Adjusting The Level Adjusters - NAMCO 500 GP Std Manual Del Operador

5-2

Fitting the Ride Assembly

1. Place the Ride Base assembly onto the monitor cabinet Support Bracket and
connect the connector.
2. Slide the Ride Base up to the Monitor Cabinet taking care not to trap any wires.
3. Fit 4off Hex head screws (M8x35) with flat and spring washers and 2off Hex head
screws (M8x16) with flat and spring washers.
Note: It is imperative that all fixings screws are fitted and fully tightened.
5-3

Adjusting the Level Adjusters

1. When the assembled game is in its final position, lower the six level adjusters (4
on the monitor cabinet and 2 on the ride base assembly) with a spanner so that
the machine is level and all castors are raised from the floor by approx. 5mm.
Tighten the lock nuts with a spanner to ensure that the level adjusters do not
move.
Note: If the location site of this machine has a polished floor it is recommended that
rubber pads are fitted under the level adjusters to prevent the machine sliding on
the floor when in use.
Connector
Hex head screw (M8x35)
with Flat & Spring Washer
Hex head screw (M8x16)
with Flat & Spring Washer
Ride Base
Page 36
Monitor Cabinet