Adjusting The Level Adjusters; Fitting The Ball - NAMCO SPIN THE SPIN Manual Del Operador

5-1 Adjusting the Level Adjusters

When the machine is in it's final position, lower the four level adjusters, with a
spanner, so that the castors are raised from the floor by approximately
5mm and the machine is level. Tighten the lock nuts with a spanner to
ensure that the level adjusters do not move.
If the machine is installed on a smooth or shiny floor, it is recommended that
rubber pads are fitted under each adjuster to prevent the machine from moving
when being played.

5-2 Fitting the Ball

1. Remove the 2 security screws (M4x12), spring and flat washers and
remove the window retainers (B) from the front window.
2. Remove the 3 security screws (M5x12) and remove the top retaining
bracket.
3. Remove the front window.
4. Remove the rail holder, only fitted for shipping, and store it in a safe place
for re-use if the machine is moved at a future date.
5. Fit the ball in the location shown in the drawing opposite.
6. Re-assemble the window and brackets in reverse order to above.
Page 32