Fitting The Ride Assembly; Adjusting The Level Adjusters - NAMCO 500 GP Dlxe Manual Del Operador

5-2

Fitting the Ride Assembly

1. Place the Ride Base assembly onto the Coin Tower Cabinet Support Bracket
and connect the connector.
2. Slide the Ride Base up to the Coin tower Cabinet taking care not to trap any
wires.
3. Fit 4off Hex head screws (M8x40) with flat and spring washers and 2off Hex
head screws (M8x20) with flat and spring washers.
Note: It is imperative that all fixings screws are fitted and fully tightened.
5-3

Adjusting the Level Adjusters

1. When the assembled game is in its final position, lower the seven level adjusters
(4 on the monitor cabinet, 1 on the coin tower base and 2 on the ride base
assembly) with a spanner so that the machine is level and all castors are raised
from the floor by approx. 5mm. Tighten the lock nuts with a spanner to ensure
that the level adjusters do not move.
Note: If the location site of this machine has a polished floor it is recommended that
rubber pads are fitted under the level adjusters to prevent the machine sliding on
the floor when in use.
Hex head screw (M8x40)
with Flat & Spring Washer
Hex head screw (M8x20)
with Flat & Spring Washer
Ride Base
Page 38
Monitor Cabinet