Troubleshooting - Ryobi RY40101 Manual Del Operador

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Handle not in position.
Mower not starting.
Mower cutting grass unevenly.
Mower not mulching properly.
Mower hard to push.
Mower not bagging properly.
Mower vibrating at higher speed.
Motor stops while cutting.

TROUBLESHOOTING

POSSIBLE CAUSE
Handle locks not locked.
Battery is low in charge.
Lawn is rough or cutting height not set
properly.
Wet grass clippings sticking to the
underside of the deck.
High grass, rear of mower housing
and blade dragging in heavy grass, or
cutting height too low.
Cutting height set too low.
Blade is unbalanced, excessively or
unevenly worn.
Bent motor shaft.
Cutting height set too low.
MAKE THE MOST OF YOUR PURCHASE!
Go to http://register.ryobitools.com and register your new tool on-line.
Your product has been fully tested prior to shipment
to ensure your complete satisfaction.
For any questions about operating or maintaining
your product, call the Ryobi
12 — English
SOLUTION
Lock upper and lower handle locks.
Charge the battery.
Adjust the cutting height.
Wait until the grass dries before mowing.
Raise cutting height.
Raise cutting height.
Replace the blade.
Stop the motor, remove key and battery.
Inspect for damage. Have repaired by
an authorized service center before
restarting.
Raise the cutting height.
Help Line!
®