Microphone Controls - Steren AMP-012 Manual De Instrucciones

MICROPHONE CONTROLS

1.- Grill: Protects the microphone cartridge and helps reduce
"breathy" and wind noise pick-up.
2.- Power switch.
3.- Microphone on LED indicator.
4.- Low battery LED indicator.
5.- Mute: Move to activate or deactivate mute function. Mute function
allows you to let the microphone on, but it won't emit any sound.
6.- Battery compartment.
7.- Microphone gain control: Gain is the transfer relation between
output and input in an audio system. Move to the right to increase
or to the left to decrease it.
INSTALLATION AND BATTERY REPLACEMENT
1.- Open the compartment lid.
2.- Place a 9V - - - battery pay
attention to the polarity.
INSTRUCTIONS
1.- Turn all knobs to min position, before to turn the equipment on. Later you can adjust them
according your needs.
2.- If you want to connect a second microphone use the MIC input jack.
3.- Open the receiver is antenna.
4.- Plug the power cord into an electrical outlet.
When you use only the portable amplifier mode be sure that the back-up battery is fully charged, you
' ' connect the amplifier to an electrical contact and move the switch in Charge position, the Led "Charge"
turns on. This LED turns off when the battery is charged. When the battery is discharged, the LED indicator
"LOW BATT" turns on, then it is necessary to charge the back-up battery.
1
2
3
4
5
7
6
15