Danby Contemporary Classic DAR044A8BBSL Guía De Utilización Y Cuidado Para El Propietario página 8

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating Instructions
DOOR REVERSAL INSTRUCTIONS
If you fi nd the direction of opening the door on your appliance inconvenient, you can change it by
following the steps shown below. To avoid personal injury or property damage, we reccommend that
someone assisst you during the door reversal process.
1. Remove the three (3) screws from the back of the worktop, lift the back of the worktop slightly and
pull the worktop forward, this will remove the worktop. See Figure 1.
2. Remove the left or right door strip cover (depending on which side you are moving the door to)
and the left or right hinge cover, then remove the two (2) upper hinge screws and remove the up-
per hinge. Loosen the upper door spindle and remove the door assembly. See Figure 2.
3. Remove the hinge pin from the door, move it to the other side of the door. See Figure 3.
4. Install the upper door spindle to the opposite side of the upper hinge, place the upper hinge onto
the other side of the cabinet, install the door strip cover and the hinge cover to the opposite side of
where you removed it. See Figure 4.
5. Loosen the adjustable foot and remove the two (2) screws around it. Remove the two (2) bottom
hinge screws, remove the bottom hinge. Reinstall the foot and two (2) screws 0where the bottom
hinge used to be. Install the bottom hinge where the foot used to be. See Figure 5.
6. Make necessary adjustments to the upper hinge and bottom hinge, reinstall the worktop in reverse
order of removing it.
Important: If the unit is placed
on its back or side for any
length of time, ensure that the
unit is allow to remain standing
upright and undisturbed for
a minimum of 4 hours before
plugging in to allow the coolant
to settle.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido