Cleaning And Maintenance - Bestron DCM1000LM Manual Del Usuario

operAtion - general
The appliance is intended only for domestic use, not for professional use.
1. On/Off switch with indication light
2. Hotplate
3. Glass pot with hinged lid
4. Water reservoir
5. Filter holder with pause-and-serve function
6. Permanent filter
7. Filter cover with vents
8. Non-slip feet
9. Cable with plug
10. Scoop
operAtion - before first use
Clean the appliance a couple of times by filling it with water only. Please observe the
following instructions. Dispose of the water after use.
operAtion - Making coffee
1. Place the appliance on a flat and steddy surface. Connect the appliance to the wall socket. Make sure
the On/Off switch (1) is set to 'O' (pilot light is extinguished).
2. Open the filter cover (7). Pour sufficient water into the reservoir (4) (not less than 2 cups and not more
than 12 cups).
3. This coffee maker is supplied with a permanent filter (6), no more paper filters needed. But if you
prefer, you can also fit a paper filter (1 x 4) in the filter holder (5). Fill the filter with the required amount
of ground coffee (the customary quantity is 1 level scoop (10) for each cup).
4. Close the filter cover (7).
5. Place the glass pot (3) on the hotplate (2).
6. Switch on the appliance (On/off switch (1) in the 'I' position: the pilot light illuminates). The coffee will
now be prepared.
7. The pause-and-serve (5) function enables you to pour a cup of coffee before the coffee maker has
finished. Replace the carafe quickly, to prevent the filter from overflowing.
The filtercover (7) is hot when the appliance is turned on! Be careful when opening the lid during use.
The hot steam can cause burns

cleAning And MAintenAnce

1. Switch off the appliance (On/off switch in the 'O' position: the pilot light
extinguishes).
2. Remove the plug from the wall socket, and if necessary allow the appliance to cool.
3. Dispose of the paper filter, where relevant. Remove the permanent filter from the casing, and clean it
under running water. Unlock the filter holder by pulling up the handle. Remove the filter holder from the
casing, and clean it under running water also. Place the filter holder back into the casing and push the
handle down to lock the filter holder. When refitting the filter holder make sure that the non-drip nozzle
projects through the opening in the filter casing.
6
5
4
3
2
1
10
16
instruction manual
7
8
Figure 1
9