Cleaning And Maintenance - Bestron AES800 Manual Del Usuario

OPERATION – Automatic switch-off
If you forget to move the selector switch to the OFF position, the unit will automatically switch off after
approx. 25 minutes. Turn the selector switch to the OFF position and then to ESPRESSO or STEAM to
turn the device on again.
CLEANING AND MAINTENANCE - Cleaning after use
Thoroughly clean the device and the loose parts after each use:
1. Unplug the power cord.
2. Allow the device and the loose parts to cool down.
3. Clean the housing with a damp cloth. Then dry thoroughly with a dry cloth.
4. All loose parts are dishwasher safe.
5. If the holes in the filter are clogged, use a needle or toothpick to puncture them.
6. Store the device in a dry place.
NOTE:
• Do not use aggressive or abrasive cleaning agents or sharp objects (such as knives or hard brushes)
when cleaning.
• Never immerse the base in water or any other liquid.
CLEANING AND MAINTENANCE - Descaling
Lime scale builds up, especially in hard water areas. This can cause the filter and
pipes in the device to become clogged. Therefore, descale the device regularly. Proceed as follows:
1. Fill the water reservoir with water and descaler with a maximum of 240 ml. Check the packaging of the
descaler for the correct ratio.
2. Place a container with a minimum capacity of approx. 240 ml under the filter holder.
3. Set the selector switch to the ESPRESSO position and wait until all the water from the device has run
into the container.
4. Then set the selector switch to the OFF position and empty the container.
5. Repeat the above process twice.
6. Then repeat the above process three more times without descaler (so only with clean water) to rinse
the appliance clean.
29
EN