Threading Pipe - Ega Master ROSCAMATIC 2 COMBI 56062 Manual De Instrucciones

1. Check to insure the cutter and reamer are to the rear of the carriage.
2. Lower die head into threading position.
3. Check that the proper size dies are in the die head.
4. Set die head to proper size.
5. Rotate throw out lever to the CLOSED position. Push throwout lever down until the release
trigger cocks.
6. Apply Thread Cutting Oil to end of the pipe.
7. Assume the correct operating posture.
8. Check directional switch to insure it is in the FOR (Forward) position. Depress and hold the
foot switch down with the left foot.
9. Engage dies with pipe using carriage lever and oil dies Thread Cutting Oil until thread is
completed. To avoid serious injury from rotating parts, allow adequate clearance between your hand
and rotating parts when oiling.
10. When thread is completed, raise throwout lever to open position, retracting dies. When die
head trigger contacts end of pipe, throwout lever automatically opens.
11. Release foot switch and remove your foot from the housing.
12. Move carriage lever away from pipe end and return die head to the UP position.
13. Check the thread for length and depth.

THREADING PIPE

Pipe threading operation
17