Ega Master ROSCAMATIC 2 COMBI 56062 Manual De Instrucciones página 18

1. Check to insure the reamer and die head are in the UP position.
2. Move pipe cutter down onto pipe and move carriage with carriage lever to line up cutter wheel
with mark on pipe.
3. Tighten cutter feedscrew handle while keeping the cutter wheel aligned with the mark.
4. Assume the correct operating posture. This will allow you to maintain proper balance and to
safely keep control of the machine and tools.
• Be sure you can quickly remove your foot from the foot switch.
• Stand facing the directional switch.
• Be sure you have convenient access to directional switch, tools and chucks.
• Do not reach across the machine or workpiece.
5. Flip the directional switch to FOR (Forward).
6. Grasp the pipe cutter's feed handle with both hands.
7. Depress and hold down the foot switch with the left foot.
8. Tighten the feedscrew handle slowly and continuously until the pipe is cut. Do not force the
cutter into the workpiece.
9. Release the foot switch and remove your foot from the housing.
10. Swing pipe cutter back to the UP position.
1. Move reamer arm down into reaming position.
2. Extend reamer by pressing latch and sliding knob toward pipe until latch engages.
3. Check the directional switch to insure it is in the FOR (Forward) position. Depress and hold the
foot switch down with the left foot.
4. Position reamer into pipe and complete reaming by pushing carriage lever with right hand.
5. Retract reamer bar and return reamer to the UP position.
6. Release foot switch and remove your foot from the housing.
18
CUTTING PIPE
Pipe cutting operation
REAMING PIPE