Machine Storage; Important - Ega Master ROSCAMATIC 2 COMBI 56062 Manual De Instrucciones

Proper lubrication is essential to trouble-free operation and long life of Power Drive. Grease main
shaft bearings every 2 to 6 months depending upon amount of Power Drive use. Grease fittings are
provided on side base, one at each end of shaft. Use a good grade of cup grease.
1. Check motor brushes every six (6) months and replace when worn to less than 1/2 inch.
2. If communicator is worn, the outer dimension of the communicator should be turned and the
mica should be undercut before replacing brushes. This should only be done by qualified repair
personnel.
1. Unplug motor receptacle from switch box.
2. Remove two (2) screws holding motor.
3. Loosen back screw in body at neck of motor and lift motor out.
Motor-driven equipment must be kept indoors or well covered in rainy weather. Store the
machine in a locked area that is out of reach of children and people unfamiliar with power drives.
This machine can cause serious injury in the hands of untrained users.

IMPORTANT!

The maker will not take responsibility for damage or malfunction as a result of the machine being
incorrectly used or, applied for a purpose for which it was not intended.
According to Waste Electrical and Electronic Equipment directive (WEEE), these ones
must be collected and arranged separately. If you have to throw them out, please, do not use the
usual rubbish. Please, contact your distributor for free recycling.
The maker guarantees to the machine owner 12 months against any manifacture defect.
This guaranteee do not cover the parts wich are consumables.
Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly
filled within one week after purchased the machine to the maker.
20
LUBRICATION
MOTOR BRUSH REPLACEMENT
MOTOR REPLACEMENT

MACHINE STORAGE

NOTES
GUARANTEE