Pioneer FH-X820BS Manual De Instrucciones página 14

NOTE
TuneStart is compatible with SXV200 or later tuner models. Not compatible with SXV100.
TuneScan™
Scan through short previews of songs you may have missed on music channels stored
on the current band of presets.
Each song in the current channel plays for six seconds at a time.
For details, refer to TUNE SCAN (scanning the songs) on page 16.
NOTE
TuneScan is compatible with SXV200 or later tuner models. Not compatible with SXV100.
TuneMix™
Create a music channel that's a blend of songs made up from the music channels stored
on the current band of presets. For details, refer to TUNE MIX on page 16.
NOTE
TuneMix™ is compatible with the SXV300 or later tuner models. Not compatible with the SXV200 or
SXV100.
Preparing for the SiriusXM Satellite Radio service
1
Press SRC/OFF to select [SIRIUSXM].
2
Press / to select Channel 0.
The Radio ID appears on the display.
In addition, the Radio ID is located on the bottom of the SiriusXM Connect Vehicle
Tuner.
NOTE
The Radio ID does not include the letters I, O, S or F.
3
Activate the SiriusXM service online or by phone.
For US Subscriptions:
• Visit www.siriusxm.com/activatenow
• Call SiriusXM Listener Care at 1-866-635-2349
For Canadian Subscriptions:
• Visit www.xmradio.ca and click on "ACTIVATE RADIO" in the top right corner
• Call 1-877-438-9677
4
[SUBSCRIPTION UPDATED] appears on the display when your SiriusXM Connect
Vehicle Tuner has been subscribed successfully.
Press any key to clear the activation message.
NOTE
The activation process usually takes 10 minutes to 15 minutes but may take up to an hour in some
cases. Do not turn off the unit until you clear the activation message in step 4.
14
En
Listening to a channel
1
Press /DIMMER, then select [CHANNEL].
You can also select the operation mode by the FUNCTION settings (page 15).
2
Press SRC/OFF to select [SIRIUSXM].
3
Press BAND/ to select a band from [SXM1], [SXM2] or [SXM3].
4
Press / to select a channel.
Pressing and holding either button will rapidly browse through the channels.
Press and hold either button then release to tune automatically. Scanning stops
when the unit receives a station. To cancel seek tuning, press
Basic operations
1
Press /DIMMER to select the operation mode [CHANNEL] or [REPLAY].
Purpose
Select a channel
Skip backward/forward
Fast forward or reverse
NOTE
You can also make various adjustments in the FUNCTION settings (page 15).
Category scan
The live broadcast for each channel in the current category plays for six seconds at a
time. Follow the steps below.
To search for a channel from a list
1
Press during playback.
2
Turn the M.C. dial to select a category.
3
Select one of the operations below.
Category scan: Press and hold the M.C. dial to switch to category scan.
Channel search: Press the M.C. dial to tune into a channel.
/ .
Operation
1 Set the operation mode to [CHANNEL].
2 Press
or .
Pressing and holding either button will
rapidly browse through the channels.
1 Set the operation mode to [REPLAY].
2 Press
or .
1 Set the operation mode to [REPLAY].
2 Press and hold
or .