Using The Cooktop; Switching The Appliance On - Fulgor Milano FCLHD 9041 HID TS BK Instrucciones Para La Instalación Y Uso

USING THE COOKTOP

The appliance is operated using the control
panel sensor keys.
Functions are controlled by touching the
sensor keys and confirmed by displays and
acoustic signals. Touch the sensor keys
from above, without covering other sensor
keys.
• TOUCH CONTROL (Fig. 7)
F
E
A. On/Off key
B. Pause key
C. Chef Cook key
D. Cooking Zone Slidebar
E. Programs key
F. Cooking zone Display
G. Timer [+] key
H. Timer [-] key
I. Timer display

• SWITCHING THE APPLIANCE ON

Press the On-Off key to switch the hob on.
All the displays relative to the cooking zones
switch on in the «0» standby position.
The control unit remains active for 10
seconds.
If no cooking zone is selected within this time,
the appliance switches off automatically.
• SWITCHING A COOKING ZONE ON
Select the desired cooking zone and press
or slide on the corresponding slidebar (D).
The power of the single cooking zone can
be adjusted in 9 different positions and will
be shown on the relative luminous display
with a level from «1» to «9».
Slide right on the slidebar to increase the
power level, slide left to decrease it.
I
min
H
D B A
• BRIDGE (Flexible cooking zones)
This function allows you to combine the
front cooking zone to the rear cooking zone
to create one large zone (zone 1+2 and 3+4,
Fig. 8).
Pay attention in placing the cookware in the
correct position on the cooking zones.
To activate the Bridge function press
simoultaneously on both Sliderbars of the
two adjacent cooking zones. The bridge
luminous symbol « »/« » will appear on
the side of the two cooking zones display
indicating that the function is active. Now it
is possible to set the heat level of the bridge
G
zone.
NOTE: the settings of the brige zone are only
enabled by the front cooking zone slidebar
C
and sensor keys.
To disable the Bridge function press
simoultaneously on both Sliderbars of the
two adjacent cooking zones. The bridge
luminous symbol « »/« » turns off.
• POT DETECTION « »
Each induction cooking zone has a pot
detection minimum limit, which varies
according to the material of the cookware
being used. For this reason, you should
choose the cooking zone which is most
suitable for the diameter of the cookware
you are going to use.
If the symbol « » appears on the cooking
zone display, it means that:
• The cookware used is not suitable for
induction cooking.
• The cookware diameter is smaller than the
one allowed by the hob.
• No cookware is on the cooking zone.
• RESIDUAL HEAT «H»
If the temperature of the cooking zone is still
high (over 50°C) after it has been switched
off, the relative display will indicate the
symbol «H» (residual heat).
The symbol will stay on even when the
appliance is switched off and will only switch
off when the burn risk in no longer present.
15
-