Troubleshooting - Saneo A019-05KR2 Manual Del Usuario

- Clean the surface of the appliance with detergent and a damp cloth.
Then, dry the appliance with a dry cloth.
Never clean the appliance with chemical products.
-

TROUBLESHOOTING

Problem Possible reasons
There is no electricity.
The 'water tank full' indicator is
on.
The room temperature is too
low or too high.
The air
conditioner
In cooling mode, the room
does not
temperature is lower than the
work.
set temperature; in heating
mode, the room temperature
is higher than the set
temperature.
In dehumidifying mode, the
temperature is too low.
The room is in direct sunlight.
The doors and windows are
open or there are heat sources
The room is
in the room.
not cool
The filter is dirty.
enough.
The air inlets and outlets are
clogged.
The air
conditioner
The air conditioner is not on a
emits an
flat surface.
unpleasant
noise.
The
compressor The air conditioner is in safety
does not mode to prevent overheating.
work.
Solutions
Plug the air conditioner into the
mains supply.
Empty the water tank.
The air conditioner must be used in
a room with a temperature between
7°C and 35°C.
Reset the temperature.
The appliance should be placed in a
room with a temperature of more
than 17°C.
Close the curtains.
Close the doors and windows and
remove the heat sources.
Clean or replace the filter.
Unclog the air inlets and outlets.
Place the air conditioner on a flat
and stable surface to reduce the
unpleasant noise.
Wait for the temperature to lower for
3 minutes, then restart the
appliance.