Warranty Terms And Conditions - Saneo A019-05KR2 Manual Del Usuario

The remote control is too far
away from the air conditioner.
The remote
The remote control is not
control does
aligned with the remote sensor
not work.
on the appliance.
The batteries do not work.
E1 code is The pipe temperature sensor
displayed. is abnormal.
E2 code is The room temperature sensor
displayed. is abnormal.
The illustrations are non-contractual.
SELECTIVE COLLECTION OF ELECTRICAL AND ELECTRONIC WASTE
Electrical products should not be disposed of with household products.
According to the European Directive 2012/19/EU for the disposal of electrical
and electronic equipment and its implementation in national law, used
electrical products must be collected separately and disposed of at the
collection points provided for this purpose. Contact your local authorities or
dealer for recycling advice.

WARRANTY TERMS AND CONDITIONS

This product is guaranteed for a fixed period of time with the distributor from
the date of purchase against any failure resulting from a manufacturing or
material defect. This warranty does not cover defects or damage resulting from
improper installation, improper use or abnormal wear and tear of the product.
The device must be returned in its original packaging and accompanied by the
receipt, subject to proper handling. Therefore, observe the operating
instructions and safety instructions given above. In addition, we cannot
guarantee your device if you or a third party has made any modifications or
repairs.
SERVICE OPERATIONS
This document describes the precautions for use by personnel responsible for service
operations.
Any person required to work on a refrigerant circuit should hold a valid and
up-to-date certificate from an assessment authority accredited by the industry and
recognising his competence to handle refrigerants safely, in accordance with the
Bring the remote control closer to
the air conditioner and align the
remote with the sensor.
Replace the batteries.
Check the pipe temperature sensor
and associated circuits.
Check the room temperature sensor
and the corresponding circuits.