Remove The Battery Pack; Operation; Start The Machine; Stop The Machine - GreenWorks LMF318 Manual Del Operador

Cortacésped
Ocultar thumbs Ver también para LMF318:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
5. Close the battery door.
The motor starts only when you put in the safety key (16).
7.7

REMOVE THE BATTERY PACK

1. Open the battery door(6).
2. Push and hold the battery release button.
3. Remove the battery pack(15) from the machine.
8

OPERATION

Wear eye protection during operation.
8.1

START THE MACHINE

1. Put in the safety key.
2. Push and hold the start button (1).
3. While you hold the start button, pull the bail switch (2) in
the direction of the handle bar.
4. Release the start button (1) to start the machine.
8.2

STOP THE MACHINE

1. Release the bail switch to stop the machine.
Wait until the blades fully stop before you start the machine
again. Do not quickly turn the machine off and on.
Always remove the safety key and battery pack after you
complete the work.
8.3

EMPTY THE GRASS CATCHER

1. Stop the machine.
NOTE
WARNING
WARNING
WARNING
English
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge flap and hold it.
5. Hold the grass catcher by its handle and unhook it from
the slots.
6. Close the rear discharge flap.
7. Empty the grass catcher.
8.4

OPERATION TIPS

Do not try to override the operation of the start button or
bail switch.
Do not tilt the machine when you start it.
Do not put hands or feet near or below the turning parts.
Keep the discharge chute clean.
Do not cut wet grass.
Higher blade height is necessary for new or thick grass.
Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other debris.
9

MAINTENANCE

Remove the safety key and battery pack from the machine
before maintenance.
Keep the motor and battery pack free from grass, leaves or
too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
10
WARNING
WARNING
CAUTION
CAUTION
CAUTION

Publicidad

Tabla de contenido
loading

Tabla de contenido