Install The Side Discharge Chute; Set The Blade Height; Install The Battery Pack; Remove The Battery Pack - GreenWorks pro ULTRAPOWER 60X RANGE 60LM21P Manual Del Operador

EN
7.6 INSTALL THE SIDE DISCHARGE
CHUTE
When you use the side discharge chute,
• do not install the grass catcher.
• keep the mulch plug installed.
1. Open the side discharge door (7) and hold it.
2. Line up the recesses of the side discharge chute (12)
below the pivot (18).
3. Close the side discharge door.
7.7

SET THE BLADE HEIGHT

The machine can be set to different blade heights.
1. Pull the height adjustment lever (6) rearward to increase
the blade height.
2. Pull the height adjustment lever forward to decrease the
blade height.
12
7
18
12
CAUTION
6
English
7.8

INSTALL THE BATTERY PACK

19
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
The machine has a battery storage compartment that helps
store the battery pack.
1. Open the battery door.
2. Align the lift ribs on the battery pack(20) with the
grooves in the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
The engine starts only when you put in the safety key (21).
7.9

REMOVE THE BATTERY PACK

1. Open the battery door.
2. Push and hold the battery release button (19).
3. Remove the battery pack from the machine.
8

OPERATION

Wear eye protection during operation.
10
21
WARNING
NOTE
NOTE
WARNING
20