Remove The Battery Pack; Operation; Start The Machine; Stop The Machine - GreenWorks 82SP25M Manual Del Operador

EN
The machine has an automatic switch function that lets the
other battery work when the first cannot operate.
1. Open the battery door (10).
2. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
The engine starts only when you put in the safety key.
7.8

REMOVE THE BATTERY PACK

1. Remove the safety key (13).
2. Open the battery door.
3. Push and hold the battery release button (14).
4. Remove the battery pack from the machine.
8

OPERATION

Wear eye protection during operation.
8.1

START THE MACHINE

18
16
1. Open the key cover (15).
2. Put in the safety key (13).
3. Push and hold the start button (16).
4. While you hold the start button, pull the bail switch (17)
in the direction of the handle bar.
5. Release the start button to start the machine.
Soft-Start
This Li-ion machine has a "soft-start" feature.
NOTE
NOTE
WARNING
17
19
English
When you start the machine, it goes to full speed after
approximately 3 seconds.
If the machine does not start, remove the battery pack and
examine the mower deck to make sure that:
• no grass catches on the blade.
• the blade can turn freely by hand.
8.2

STOP THE MACHINE

1. Release the bail switch to stop the machine.
Wait until the blades fully stop before you start the machine
again. Do not quickly turn the machine off and on.
Always remove the safety key and battery pack after you
complete the work.
8.3

AUTOMATIC BOOST FUNCTION

When the machine cuts high grass the rpm is automatically
increased in order to keep a good cutting and collecting
results.
When the machine goes back to usual cutting conditions the
rpm automatically goes back to the standard rpm to keep
work time.
8.4 OPERATE THE SELF-PROPEL
SYSTEM
18
16
1. Start the machine.
2. While you hold the bail switch (17), push the self-propel
lever (18) in the direction of the handle bar.
3. Hold the bail switch and the self-propel lever at the same
time with your right hand.
4. Adjust the speed control button (19) with your left hand.
• Push the speed control button in the direction of the
Rabbit Symbol to increase the speed.
10
NOTE
WARNING
WARNING
17
19