Usb/Sd/Ipod; Connecting A Usb Device; Inserting The Sd - Kenwood DNX997XR Guia De Inicio Rapido

USB/SD/iPod

Connecting a USB device

1
Connect the USB device with the USB
cable. (P.34)
Ñ
Disconnect the USB device
1
Press the [HOME]/[ ] button.
2
Touch a source other than [USB].
3
Detach the USB device.
Ñ
Usable USB device
You can use a mass-storage-class USB device
with this unit.
The word "USB device" appearing in this manual
indicates a flash memory device.

Inserting the SD

DNX997XR
1
Press the [G] button.
2
Touch [OPEN] to the panel fully opens.
3
Insert the SD card into the slot until it
clicks.
4
Press the [G] button.
DNX697S / DNX577S
1
Insert the microSD card into the slot until
it clicks.
Ñ
Remove the SD card
DNX997XR
1
Press the [G] button.
2
Touch [OPEN] to the panel fully opens.
3
Push the SD card until it clicks and then
remove your finger from the card. The
card pops up so that you can pull it out
with your fingers.
4
Press the [G] button.
DNX697S / DNX577S
Push the microSD card until it clicks and then
remove your finger from the card. The card
pops up so that you can pull it out with your
fingers.
USB/SD/iPod
19
English