GreenWorks GPW 1602 Manual Del Operador página 17

USING THE SPRAY WANd TRIGGER
For greater control and safety, keep both hands on the pressure washer gun at all times.
■ Pull back and hold the trigger to operate the pressure washer.
■ Release the trigger to stop the flow of water through the spray wand.
TO ENGAGE THE LOCK-OUT
■ Push up on the lock-out until it clicks into the slot. This will prevent any unintentional starts of the
pressure washer.
TO dISENGAGE THE LOCK-OUT
■ Push the lock-out down and into its original position. For the most effective cleaning, the spray tip
should be between 8 in. and 24 in. from the surface to be cleaned. If the spray is too close it can
damage the cleaning surface.
W A R N I N G
Do not slide lock-out button when you have the trigger at back position.
OPERATION
(See Figure 8-1.)
(See Figure 8-2.)
Locked
Fig. 8-1
EN - 17
Unlocked
Fig. 8-2