IMG STAGELINE PARL-12DMX Manual De Instrucciones página 12

connected via a mains cable with an IEC plug and
GB
an IEC inline jack (e. g. AAC-170/SW from the
product range of MONACOR) to the mains jack (4)
of the second unit. The second unit can again be
connected to the third unit etc., until all units are
connected in a chain. Thus, a maximum of 50 units
may be interconnected. Then the 51st unit must
have a mains connection of its own.
Caution: The unit must not be connected to the
mains voltage via a dimmer!
For a more convenient operation it is recommended
to connect the unit to a socket which can be
switched on and off via a light switch.
5 Operation
5.1 Operation without DMX control unit
5.1.1 Music-controlled programmes
1) Press the button FUNC (6).
2) Select the function
DOWN and confirm with the button ENT.
3) Select the desired control programme with the
button UP or DOWN and confirm with the button
ENT. The display (5) shows the programme:
The lighting colour is changed by music
control (mixed colours only).
Music-controlled stroboscope with colour
change (mixed colours only)
Music-controlled stroboscope with colour
change (primary colours and mixed
colours)
The lighting colour is changed by music
control (primary colours and mixed
colours).
If the music is played with a clear rhythm in the
bass range at sufficient volume, the selected pro-
gramme is controlled via the microphone (3). Adjust
the control SENSITIVITY (2) for the microphone
sensitivity so that the dynamic power of the music
is reproduced by the unit in an optimum way. For
programmes
matically changed during music breaks after a few
seconds.
5.1.2 Programmes running automatically
1) Press the button FUNC (6).
2) Select the function
DOWN and confirm with the button ENT.
12
with the button UP or
and , the colours are auto-
with the button UP or
3) Select the desired control programme with the
button UP or DOWN and confirm with button
ENT. The display (5) shows the programme:
The lighting colour is changed automat-
ically after approx. 5 s in each case.
Automatic colour change with slow fad-
ing in and out
Automatic colour change with slow fad-
ing in and then immediate colour change
Automatic crossfading of different
colours
same as
Automatic colour change with slow fad-
ing out in each case.
5.1.3 Colour spotlight with selectable colour
1) Press the button FUNC (6).
2) Select the function
DOWN and confirm with the button ENT.
3) Select the desired colour with the button UP or
DOWN and confirm with the button ENT. The
display (5) shows the number of the colour:
white
red
green
blue
purple
cyan
yellow
pink
orange
light green
5.2 Interconnection of several
PARL-12DMX units
Several PARL-12DMX units may be interconnected
(master-slave operation). Then all slave units can
be controlled in sync with the master unit.
1) Connect the DMX OUTPUT (13) of the master
unit via a 3-pole XLR cable (e. g. series MEC-...
or MECN-... from the product range of MONA-
COR) to the DMX INPUT (12) of the first slave
unit.
2) Connect the DMX OUTPUT of the first slave unit
to the DMX INPUT of the second slave unit, etc.
until all units have been connected in a chain.
3) No DMX signal must be present at the DMX
INPUT of the master unit. Adjust the slave units
to the DMX address 001 (
with the button UP or
chapter 5.4.2).