How To Take A Reading - Object - HealthSmart 18-545-000 Guia Del Usuario

How To Take A Reading - Object

NOTE: Make sure the measurement sensor is clean before taking a reading. Be
sure the thermometer is set to measure the temperature of an object.
1. If the thermometer is off, press any button to turn it ON. The
screen should display the ambient temperature, Fig 1.
2. Press the SCAN button and M (Memory) button together
to switch between Object and Forehead mode. The screen
should appear like Fig. 2 when in Object mode.
3. Aim the front of the thermometer at the object you want to
measure, Fig. 3. Hold the thermometer approximately 0" ~ 2"
(0~5 cm) away from the object.
4. Press and hold the SCAN button. The screen should appear
like Fig. 4 and begin taking the measurement.
NOTE: Holding the measurement button down will give a
continuos reading until the button is released.
5. After the test is complete, press the M (Memory) button or
wait 1 minute for the display to return to standby mode and
display the ambient temperature. After 1 minute in standby
mode, the thermometer will automatically shut OFF.
NOTE: The LED light will NOT illuminate as it does in the
Forehead measurement mode.
10
FIG. 1
FIG. 2
0"~2"
FIG. 3
FIG. 4