ESAB PCC-10 Manual De Instrucciones página 21

SeCTION 3
WArNINg
Typical Installation -
user-supplied single phase fused power disconnect box with
receptacle and plug
eleCTrIC ShOCK CAN KIll! BefOre MAKINg eleCTrICAl INPuT
CONNeCTIONS TO The POWer SOurCe, "MAChINerY lOCKOuT
PrOCeDureS" ShOulD Be eMPlOYeD. If The CONNeCTIONS Are
TO Be MADe frOM A lINe DISCONNeCT SWITCh, PlACe The SWITCh
IN The Off POSITION AND PADlOCK IT TO PreVeNT INADVerTeNT
TrIPPINg. If The CONNeCTION IS MADe frOM A fuSe BOx, reMOVe
The COrreSPONDINg fuSeS AND PADlOCK The BOx COVer. If IT IS
NOT POSSIBle TO uSe PADlOCKS, ATTACh A reD TAg TO The lINe
DISCONNeCT SWITCh (Or fuSe BOx) WArNINg OTherS ThAT The
CIrCuIT IS BeINg WOrKeD ON.
figure 3.3 Input Connection Diagram
21
INSTAllATION
Input Power Cable