List Of Components - Chicco Snappy Instrucciones De Uso

Wash by hand in cold water
nd
he
Do not bleach
ch
Do not tumble dry
er
he
Do not iron
fe
se
Do not dry clean
re
le
Periodically wipe clean plastic parts with a soft damp cloth.
Always dry the metal parts to prevent the formation of rust if
n-
the stroller has come into contact with water.
Certain models include a seat pad which should be cleaned
he
following the instructions on its care label
a
MAINTENANCE
Lubricate the moving parts only if necessary, with the light
en
application of a silicone based lubricant. Regularly check the
condition of the wheels and, keep them clean of dust and sand.
ed
To avoid friction that may prevent the correct operation of the
e-
stroller, ensure that all the movable plastic parts placed
along the metal frame are clean of dust, dirt or sand. Keep the
ur
stroller in a dry place.
ts

LIST OF COMPONENTS

rs
Check that you have all the parts required for this model
n-
before assembling the product. If any parts are missing,
please contact the Chicco Customer Care Service. No tools
on
are needed to assemble the product. The following parts are
wn
needed to assemble the product:
1 stroller
n-
1 hood
1 rain cover
re
1 stroller carry bag (79255.930)
re
1 carry-all basket (79255.930)
als
1 shoulder carry strap (79254)
1 seat pad (79254)
ts
OPENING INSTRUCTIONS
1. Release the closure latch (diag. 1)
er
2. Open the stroller (diag. 2).
3. Press the safety lock down with your foot as shown in the
or
drawing (diag 3.) WARNING: pushing down the bar C which
connects the two rear wheels (see 'components') does not
guarantee that the stroller is open correctly.
n-
4. Fit the sun hood (diag. 4A) on the stroller, by turning it
or-
towards the front and use the Velcro fasteners on the edges to
secure it to the frame (diag. 4B)
WARNING: ensure that the sun hood is securely fitted on the relative
support by pressing it downwards until you hear it click into place.
be
RECLINING THE BACKREST
5. The backrest can be reclined to 2 different positions. After
releasing the clips on the backrest (diag. 5 A), open the zips on
h a
either side of the seat (diag. 5 B).
are
WARNING: this adjustment is more difficult when the child is
ow
seated in the stroller. We recommend you adjust the backrest
before placing your child in the seat.
BRAKES
6. To apply the brakes, press the levers on the rear wheels
downwards (diagram 6). WARNING: the brakes are connected
and are applied together.
When the brake levers are up, the wheel brake is off.
THE BRAKES MAY NOT FUNCTION AT THEIR OPTIMUM LEVEL
ON STEEP SLOPES.
WARNING: Always apply the brakes whenever the stroller is
stationary. Never leave the stroller on a sloping surface with a
child inside, even with the parking brake ON.
WARNING: after applying the brake lever, check that the
brakes are locked in place on both rear wheels.
FRONT SWIVEL WHEELS
The stroller has front swivel wheels.
7. To unlock the swivel wheels, lower the lever fitted between the
two wheels (diag. 7). Use the swivel wheels on smooth surfaces.
To lock the wheels, pull the lever in an upward direction.
WARNING: the swivel wheels make the stroller easier to
manoeuvre; it is however recommended to use the wheels in a
locked position on uneven ground to guarantee better stability
(on gravel, unpaved roads etc.)
WARNING: Both wheels must be locked or unlocked at the
same time.
SAFETY HARNESS
8. All strollers are fitted with a 5 point safety harness (diag. 8A).
Adjust the shoulder straps so they fit over the child's shoulders.
Always use the safety harness together with the crotch strap.
Always check that the safety harness is fitted correctly.
WARNING: the safety harness must always be fastened to
guarantee complete safety for your child. For extra safety, the
stroller is fitted with D rings, which can be used to fit a separate
safety harness, compliant with BS 6684 Standards. The rings
are fitted on the right and left side of the stroller seat, as seen
in points A and B.
Snappy Deluxe: Diag. 8B-8C. Bring the upper harness strap
clasp (A) in line with the triangle on the lap belt clasp (B) and
then insert them both in the harness buckle (C). Press the
centre button (D) to release the safety harness straps.
CLOSING THE STROLLER
WARNING: when closing the stroller, ensure that your child
and all other children are at a safe distance. Ensure that during
these operations the moving parts of the stroller do not come
into contact with your child.
9. To close the stroller, pull the sun hood back, release the lock
system 1 (see 'components') by pulling it towards you in a
downward direction; then push it upwards to unlock the main
locking system (diag. 9 A).
WARNING: THE STROLLER FEATURES A SECONDARY
LOCKING SYSTEM TO PREVENT ACCIDENTAL CLOSURE. DO
NO TRY TO CLOSE THE STROLLER WITHOUT UNLOCKING
THE SECONDARY LOCKING SYSTEM (see 'components').
To release the secondary locking system, press the red pedal
shown in the diagram (diag. 9 B).
10. Push the handles in a forward direction and fold the stroller
until it is completely closed (diag. 10).
11. When it is closed, the hook on the side automatically locks
the stroller (diag. 11 A) to prevent it from accidentally opening.
The rear wheels can be locked in place so the stroller can be
simply stood up, rested against a vertical surface, on its own
(diag. 11 B).
17