Honeywell Home RTH6360 Serie Guía Rápida De Instalación página 4

Quick Installation Guide
9
Disconnect the wires and remove the old wall plate.
Use a screwdriver to release wires from terminals. Then, use a wire label to
identify each wire as it's disconnected. The letter on the wire label should
match the letter on the terminal.
Tip: To prevent wires from falling back into the wall, wrap the wires around a
pencil.
Installing your RTH6360 thermostat
RTH6360
Thermostat
10
Bundle and insert wires through the UWP.
Pull open the UWP and insert the bundle of
wires through the back of the UWP.
Make sure at least 1/4-inch of each wire
is exposed for easy insertion into the wire
terminals.
UWP
Screws Mounting
System
4
www.honeywellhome.com
Anchors Wall