Tripp-Lite PDUMNH15 Manual Del Propietário página 5

3. Installation
2
2U Rack Mounting (PDUMNH30): Attach
the included brackets to the sides of the PDU
(STEP ) with the included screws. After
2A
installing the brackets, position the PDU in the
rack and install four user-supplied screws through
the unit's brackets (STEP
rails as shown.
3 0U Rack Mounting: Remove the screws
attaching the mounting brackets to the PDU,
change the orientation of the brackets as shown
and reattach the brackets. Use only the screws
supplied by the manufacturer or their exact
equivalent (#6-32, 1/4" flat head). Attach the
PDU vertically by inserting two or more user-
supplied screws through the PDU mounting
A
brackets and into mounting points in the rack
B
or rack enclosure.
4 5
Wall or Under-Counter Mounting:
Remove the screws
C
brackets to the PDU, change the orientation of the
brackets as shown and reattach the brackets. Use
only the screws supplied by the manufacturer or
their exact equivalent (#6-32, 1/4" flat head).
Attach the PDU to a stable mounting surface by
inserting two or more user-supplied screws
through the PDU mounting brackets
secure points on the mounting surface.
6
Cord Retention Shelves Attachment
(PDUMNH30, Optional): Use included screws
to attach the cord retention shelves to the top and
bottom of the front panel of the PDU as shown.
201006064 93-3049.indb 5
( continued )
) and into the rack
2B
C
attaching the mounting
A
and into
B
2A
2B
B
3
B
4
C
5
6
5
A
C
A
C
B
A
10/6/2010 4:48:43 PM