Publicidad
Idiomas disponibles
Idiomas disponibles
Igniting the Main Burners
Using the E2i™ Electronic Ignition to
Ignite the Main Burners
Each control knob operates an individual burner, and
each burner ignites independently. Ignite the main
burners starting from left to right. All burners should
be lit for preheating, however, all burners do not have
to be lit while grilling.
1) Open the grill lid (A).
2) Check that all burner control knobs (including side
burner control knob) are in the off
by pushing in and turning knobs clockwise (B).
Note: It is important that all burner control knobs are
in the off
position before turning on the LP tank.
If they are not, the flow limiting device built into the
regulator will activate, limiting the flow of gas from
the LP tank.
3) Turn the LP tank on by slowly turning the tank valve
counterclockwise; wait 60 seconds (C).
Note: It is important that the LP tank is turned on
slowly. If it is opened too quickly, the flow limiting
device built into the regulator will activate, limiting the
flow of gas from the LP tank.
4) Begin with the burner furthest to the left.
Push the burner control knob in and slowly turn
it counterclockwise towards the ignite
until you hear ticking (D). Once ticking starts, hold
the knob in that position for 1-2 seconds and then
slowly continue turning counterclockwise. The
burner should ignite before the high+
5) Check that the burner is lit by looking through the
cooking grates and through the half-circle cutout in
the Flavorizer™ bar.
6) Once burner is ignited, continue turning the knob
counterclockwise until you reach the desired
position.
7) If the burner does not ignite within 4 seconds,
turn burner control knob to the off
wait five minutes to allow the gas to clear before
attempting to light the burner again.
8) If the burner ignites, repeat steps 4 through 6 to
light the remaining main burners.
Should the burners fail to ignite using the electronic
ignition, refer to the TROUBLESHOOTING section.
There you will find instructions on igniting the grill
with a match to help determine the exact problem.
To Extinguish Main Burners
1) Push each burner control knob in and then turn
clockwise all the way to the off
2) Turn gas supply off at the LP tank.
GET FREE SPECIAL CONTENT
14
position. Check
position
position.
position and
position.
WARNING: Open lid during ignition.
m
WARNING: Do not lean over open grill while
m
igniting or cooking.
WARNING: If ignition does not occur within
m
four seconds of attempting to light the first
burner, turn the burner control knob to
the off position. Wait five minutes to allow
accumulated gas to dissipate, and then repeat
the lighting procedure.
Publicidad
