Maintenance - Husqvarna 320iB Mark II Manual Del Usuario

4. Press the cruise control button again to deactivate
the cruise control function.
To temporarily increase the airflow
1. Start the product. See
11 .
Introduction
WARNING: Before you do any maintenance
work you must read and understand the
safety chapter.

Maintenance

Clean the outside of the machine with a clean and dry cloth. Never use water.
Keep handles dry, clean and free from oil and grease.
Make sure that the start/stop button works correctly and is not damaged.
Make sure the power trigger is functioning properly with regard to safety.
Check that nuts and screws are tight.
Check that the battery is intact.
Check the battery's charge.
Check that the release buttons on the battery works and locks the battery into
the machine.
Check that the battery charger is intact and functional.
Check that all couplings, connections and cables are intact and free from dirt.
Check the connections between the battery and the machine and also check the
connection between battery and the battery charger.
12
To start the product on page
Maintenance
2. Press and hold the boost button to get the maximum
airflow, the LED comes on.
a) 530iBX has unlimited boost time.
b) 320iB Mark II has a limited boost time of 30
seconds. Release and press the boost button
again.
3. Release the boost button to use the product with
normal air flow.
Maintenance schedule
WARNING: Remove the battery before you
do maintenance.
The following is a list of the maintenance steps that you
must do on the product.
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
788 - 002 - 25.02.2020
X