Connecting The Gas; How To Use - HAEGER 1-N5-H Instrucciones De Uso

Connecting the Gas

 The device was set to be connected with a flexible rubber tube (hose) and having a length not exceeding 125
cm.
 Be sure that after connecting the hose it is not creased or is in contact or near the hot zones. Whether the tube or
the regulator/reducing gas pressure should be certified and marked in accordance with applicable standards.
The fixing of the pipe to the unit and the gearbox must
be done by clamps.
 For a better fixation it is recommended that first heats
the tube dipping it for one minute in hot water.
 After the connections, check the leakage of the whole
gas circuit retaining the ignition buttons off and the
bottle reducing gas pressure knob open, and then
applying a mixture of water and soap. The blistering
means that there is gas leakage.

How to use

Make sure the ignition button is set to "OFF" then turn on the stopcock of the gas cylinder at full. Push the ignition
button and turn it to the left until a clicks is heard. Make sure that the burner has been lit.
When the unit is used after being left unused for a considerable period, it sometimes
happens that the burner fails to ignite. This is because air has been trapped in the rubber
tubing. Repeat turning the ignition knob a few times until gas comes through.
5
English