Specifications - Rockford Fosgate PRO Serie Instalación Y Funcionamiento

S
PECIFICATIONS
MODEL- PRO
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4Ω Load Mono
2Ω Load Mono
Dimensions: (with Endbell)
Height
Width
Length
Battery Fuse Rating (Amp)
(External to Amplifier)
Fuse Type
Signal-to-Noise Ratio
Crossover Slope
Crossover Frequency
Frequency Response
Bandwidth
Damping Factor @ 4Ω (at output connector )
Slew Rate
IM Distortion (IHF)
Acceptable Signal Voltage Range
Protection
Equalization (45Hz Punch Bass)
Input Impedance
The Blue Rockford PCB are exclusive for the PRO Series of Rockford amplifiers.
Specifications subject to change without notice
12
bd1000P
500 Watts x 1
1000 Watts x 1
2.4" (6.1cm)
9.8" (24.89cm)
13.35" (33.96cm)
100A
Not Supplied
AGU
24dB/octave Butterworth
variable LP (Low Pass) from 50Hz to 250Hz
Variable from 250mV to 4.5V (RCA Input)
NOMAD - Internal analog-computer output protection
circuitry limits power in case of overload. Thermal
switch shuts down the amplifier in case of overheating.
Variable from 0dB to +18dB @ 45Hz
bd1500P
750 Watts x 1
1500 Watts x 1
2.4" (6.1cm)
9.8" (24.89cm)
18.35" (46.74cm)
1500A
Not Supplied
AGU
>90dB A-weighted
20Hz to 20kHz ±0.5dB
20Hz to 200kHz ±3dB
>200
30 Volts/ms
<0.05%
20k ohms