Troubleshooting - Franke FCB 360 V NE E Manual De Uso Y Instalación

TROUBLESHOOTING

What to do if...
The control panel is switched
off, the appliance does not
work�
The inside light does not work�
The inside light flashes�
The temperature inside the
compartments is not low
enough�
There is water on the bottom of
the refrigerator compartment�
Excessive amount of frost in the
freezer compartment�
The front edge of the appliance,
at the door striker seal, is hot�
One or more green symbols
are flashing continuously and
it is not possible to change the
temperature set�
The temperature of the
refrigerator compartment is too
cold�
Possible reasons
There may be an
appliance power supply
problem�
The appliance could be in
On/stand by mode�
The light may need to be
replace�
Malfunction of a technical
component�
Door alarm active�
It is activated when the
refrigerator compartment
door remains open for a
prolonged period of time�
There could be various
causes (see "Solutions")�
The defrost water drain is
blocked�
The door of the freezer
compartment does not
close properly�
This is not a defect� It
prevents condensation
from forming�
Malfunction alarm�
The alarm indicates a fault
in a technical component�
• The set temperature is
too cold�
• A large amount of fresh
food may have been
placed in the freezer
compartment�
Solutions
Check that:
• there is not a power outage;
• the plug is properly inserted in the power
socket and the mains double-pole switch (if
present) is in the correct position (i�e� allows
the appliance to be powered);
• the household electrical system protection
devices are efficient;
• the power cable is not damaged�
Turn the appliance on by briefly pressing the
"Temp." button (see On/Stand-by function)�
Disconnect the appliance from the power
supply and contact the Technical Assistance
Service if you need a replacement�
To stop the alarm, close the refrigerator door�
On reopening the door, check the light
works�
Check that:
• the doors close properly;
• the appliance is not installed near a heat
source;
• the set temperature is adequate;
• the circulation of air through the vents
at the bottom of the appliance is not
obstructed (see installation section)�
Clean the defrosting water drain (see section
"Cleaning and Maintenance")�
• Check that there is nothing preventing the
door from closing properly�
• Defrost the freezer compartment�
• Make sure the appliance has been correctly
installed�
No solution is necessary�
Contact Technical Assistance Service�
• Try to set a less cold temperature�
• If fresh food has been placed in the freezer
compartment, wait until it has fully frozen�
• Turn off the fan (if present) following the
procedure described in the paragraph "FAN"�
EN
13