Troubleshooting - Franke FCB 320 TNF NE F Manual De Uso Y Instalación

TROUBLESHOOTING

What to do if...
The control panel is
switched off, the appliance
does not work�
The inside light does not
work�
The temperature inside the
compartments is not low
enough�
The front edge of the
appliance, at the door striker
seal, is hot�
Acoustic signal sounds�
Super Freeze Super Freeze
Super Freeze Super Freeze
Super Freeze Super Freeze
Possible reasons
The appliance could be in On/Standby
mode�
There may be an appliance power
supply problem�
The light may need replacing�
The appliance could be in On/Standby
mode�
There could be various causes (see
"Cures")�
This is not a defect� It prevents
condensation from forming�
Door open alarm
It is activated when a door remains open
for a long period of time�
Black Out alarm
It is activated in case of a prolonged
power outage causing an increase in the
freezer compartment temperature�
Note: A different product temperature
cannot be set until the Black Out alarm is
deactivated.
Freezer compartment temperature
alarm
The freezer compartment temperature
alarm indicates that the compartment
temperature is not optimum� This may
happen: with first use, after defrosting
and/or cleaning, if large amounts of
food are placed inside the freezer or
when the freezer door has not been
closed properly�
Solutions
Activate the appliance with the button 1�
Make sure:
• there is not a power outage
• the plug is properly inserted in the power socket and the mains
double-pole switch (if present) is in the correct position (i�e� allows
the appliance to be powered)
• the household electrical system protection devices are efficient
• the power cable is not broken�
Contact the Authorized service center�
Activate the appliance with the button 1�
Make sure:
• the doors close properly
• the appliance is not installed near a heat source
• the set temperature is adequate
• the circulation of air through the vents at the bottom of the
appliance is not obstructed�
No cure is necessary�
Close the doors of the product to deactivate the acoustic signal�
Before deactivating the acoustic signal, it is advisable to pay attention
to the Freezer temperature leds, corresponding to the highest
temperature reached in the freezer compartment during the black
out� Press the "Stop Alarm" button briefly to deactivate the acoustic
signal� After pressing the button, the temperature led shows the set
temperatures again� If the freezer compartment has not yet reached
the optimum food preservation temperature, the freezer compartment
temperature alarm could be activated (see freezer compartment
temperature alarm)� Check the food before consuming it�
Pressing button (1) or button (6) button the acoustic alarm is snoozed
EN
13