Descargar Imprimir esta página

Polk Audio DB840 El Manual Del Propietario página 2

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
ENGLISH
SAFE LIMITS OF OPERATION
Polk Audio specifies the recommended amplification range
for each of its passive (non-amplified) loudspeakers. Typically
that specification will be expressed as a range of power such
as 20-200 W (per channel). It is important to understand
what those numbers mean when choosing a receiver or
amplifier for your Polk loudspeakers. The lower number
indicates the lowest continuous rated power that will yield
acceptable performance in a typical listening environment.
The higher number indicates the highest per channel power
that should be used with your Polk speakers. That number
should not be confused with a "Power Handling" specification
and it does not imply that the speaker will safely handle
that full amount of power on a long-term basis. We specify
a wide range of power ratings because not all electronics
manufacturers use the same method for rating power.
In fact, high quality lower-rated amplifiers sound better and
play louder than low quality units with a higher power rating.
Automobile horsepower is a good analogy. Your car probably
has far more horsepower than it needs for your daily commute
and is likely capable of going well over 120mph (190km/hr).
Having that extra power is good for on-ramp acceleration
BRING ON THE NOIZE!
Please inspect each loudspeaker carefully. Notify your
Polk Audio dealer if you notice any damage or missing items.
Keep the carton and packing material. They will do the best
job of protecting your speakers if they need to be transported.
BUILDING A HOME FOR YOUR SUBWOOFER—
db SUB ENCLOSURE 101
To get the best performance from your db Subwoofers,
you must use a Subwoofer Enclosure. Don't bother
using them in "free air," with no sub box, just popped into
the back deck of your car. You will not get very good
performance from your subwoofers if you do this.
They are not designed to be installed infinite baffle or
"free air." This will void the warranty.
You can build your own box, buy a pre-built box or a box kit,
or have your Polk Audio dealer design and build a custom sub
enclosure for you. Your db Subwoofers were designed to work
well in a wide variety of enclosure sizes and configurations.
If you choose to build your own enclosure, be sure to build
it well. Make certain it's properly sealed and airtight for
maximum bass performance.
and danger avoidance (like getting away from brain-eating
zombies) but that doesn't mean that it is advisable to operate
your car on North American highways at full power and
maximum speed for an extended period of time. Just ask
your local state trooper if you are in doubt. Similarly, we
recommend using amplifiers and receivers with rated power
above the Power Handling limits of our speakers because
having extra power available for short term peaks is conducive
to better sound quality, maximum dynamic range and effortless
high volume output. But we strongly urge you not to use the
full power of your amplifier or receiver for daily listening.
Loudspeakers can be damaged when an amplifier, regardless
of its wattage, is made to play at higher listening levels than its
power can clearly produce. Operation at this level can result in
very high levels of audible distortion originating in the
amplifier, which can add a harsh, gritty sound to your listening
material. If you hear distortion—turn the volume down
or risk damaging your speakers. You can damage just
about any speaker, regardless of power rating, if you drive an
amplifier to or beyond the point of distortion.
Polk Audio Customer Service is available from
9am–6pm, EST, Monday through Friday, at 800-377-7655
(US & Can only, outside the US please call
410-358-3600) or email us at polkcs@polkaudio.com
Please do not hesitate to call us if you have questions
about your speaker system. We love this stuff.
RECOMMENDED SEALED ENCLOSURES
db840 & 840
0.35 cu ft (9.9L)
DVC
db1040 & 1040
0.66 cu ft (18.7L)
DVC
db1240 & 1240
0.88 cu ft (24.9L)
DVC
For more information about enclosures and configurations, log
on to www.polkaudio.com/car/toolbox/subboxplans/. Or call
Polk Audio's Customer Service Department for a FAXback Sub
Enclosure info sheet.
M o r e I n f o @ w w w . p o l k a u d i o . c o m / c a r
3

Publicidad

loading

Este manual también es adecuado para:

Db1040Db1240Db840dvcDb1040dvcDb1240dvc